Current location: JICS Archive > Vol. 5 > No. 4 > Articles : 10

Structure and Morphology of Nanostructured Zinc Oxide Thin Films Prepared by Dipvs. Spin-Coating Methods

M.H. Habibi^a,* and M. Khaledi Sardashti^a

^aCatalysis Division, Department of Chemistry, University of Isfahan, 81746-73441, Isfahan, Iran

In this study, we use dipping and spinning methods to coat glass slides with sol-gel ZnO thin films, composed of zinc acetate dihydrate, monoethanolamine (MEA), de-ionized water and isopropanol. The effect of the annealing temperature on the structural morphology and optical properties of these films is investigated. These ZnO films were preheated at 275 °C for 10 min and annealed either at 350, 450 or 550 °C for 60 min. As-deposited films, formed by amorphous zinc oxide-acetate submicron particles, are transformed into a highly-oriented ZnO after thermal treatment. The surface morphology, phase structure and optical properties of the thin films were investigated by scanning electron microscopy, X-ray diffraction (XRD) and optical transmittance. Both techniques produced nanostructured ZnO thin films with well-defined orientation. The annealed films were transparent in the visible range with an absorption edge at about 375 nm and a transmittance of ca 85-90% with an average diameter of 40 nm. XRD results show the film was composed of polycrystalline wurtzite, with a preferential c-axis orientation of (002) and a single sharp XRD peak at 34.40, corresponding to the hexagonal ZnO. The grain size is increased by the annealing temperature. Both coating techniques create sol-gel ZnO films with the potential for application as transparent electrodes in optic and electronic devices.

Keywords: Nanostructure, Sol-gel, Thin film, Spin coating, Dip coating, ZnO